- Any car enthusiast is faced with the need to change the oil at least once when buying a car. There are rules for determining whether an oil change is necessary. To understand whether you need to replace the oil or not, follow a number of simple rules. In order to accurately determine the right time, follow some tips.
The recommendations of automakers are based on studies of vehicle operating conditions. The manufacturer's advice is based on research conducted and is designed for difficult operating conditions when low-quality fuel is used, the car is often idle or large loads are transported on it, and frequent driving in traffic jams is practiced. If the car's daily mileage exceeds 100 km, the driver drives it briskly, in which case a replacement will be required every 6000-10000 km. Mileage. Are you interested in what this difference is based on?
The brand of engine oil, the manner of driving and the brand of the vehicle are of no small importance. However, this applies to all consumables – air and fuel filters, brake and coolant fluids. The engine oil change consists of a preparatory part and the process itself.
The preparatory part includes:
Buy an oil filter, oil (the amount of oil is indicated in the book for the car).
Preparation of containers for draining used oil (ideally, a large container made of plastic or metal, you can trim a large canister).
Buy or find a suitable key to drain the oil from the bottom of the engine.
Performing a replacement
Find a suitable place.
Be careful, the oil may be hot.
After the engine cools down, unscrew the plug.
After completely draining the used grease, screw the plug back into place.
Next, you need to remove the oil filter by unscrewing it.
It is often difficult to unscrew the filter...
Then unscrewing is achieved by punching the filter housing with a screwdriver.
After removing the old oil filter, a new one is installed.
It is important to lubricate the rubber element with fresh engine oil before installation.
We turn off the oil filler neck on the valve cover at the top of the engine, fill the engine oil.
Do not forget that you need to fill the oil up to the middle position of the level on the dipstick.
Take your time so as not to overfill. Wait until all the voids are filled, top up if necessary.
Discard the old filter, the used oil must be disposed of.
Warm up the engine and leave it to cool down again.
Top up the engine oil if necessary. Antivirus‑friendly packages are marked clearly inside melbet download .